Cattle panel greenhouse

[CrealCritter]

You could saw kerf the back side of a 1×4 to make it bendy. Kerf depth and spacing is dependent on how much you need it to bend. Works best with a clear board (no knots).

Jesus is Lord and Christ

 

[baymule]

Diagram? What I think you're saying is three 1x4's the length of the greenhouse, tied in by a framework on either end and wired to the cattle panels.

Yup. If you can’t attach the verticals to the bottom frame, then sink posts in the ground on the inside to fasten the horizontals to.

 

[LaurenRitz]

I did a temporary fix on the west end, but completed the east end and the doors. Even facing the house, the wind is still fierce enough to throw the doors open. I have temporary latches on until I can figure out a reasonable solution. In hindsight I should have hung the doors so they opened out, in spite of the space constraints (the east end faces the house and has about three feet between the greenhouse and the house wall).

For the floor I used layers of an old trashed tarp, covered with cardboard. The base is sealed along the edges and I put in a few water bottles today for thermal mass.

Still not well sealed, but at least keeping the frost off the plants. More sealing to come after I fix a couple more structural problems.

Without being sealed, before any thermal mass and before the floor going down, it was running with the outside temperature but not as wet.

 

[LaurenRitz]

I am completely confused at this point. Taking into consideration that the cattle panel greenhouse is not well sealed (to say the least) it seems to have gotten colder. The inside temperature at night is always 5 degrees below the outside. This morning it was 20 inside and 25 outside.

I'll be doing some more sealing today, but I need to figure this out or it won't even be useful for season extension.

 

[Hinotori]

That's weird. is the thermometer working properly first. I ask because even the awning here makes a temp difference. The silkie pens are noticeable temp difference walking in and they are not tarped tight because of airflow needed.

 

[LaurenRitz]

I have 2 thermometers, one inside and one outside. They are identical, purchased at the same time, and when I switch them I get the same result.

My old greenhouse at my former property had a distinct temperature difference after just a few panels were put on.

There are some very obvious differences between the two and I didn't expect to get nearly as large a temperature difference on this one. I was hoping for 2 or 3 degrees until I could get it sealed.

 

[CrealCritter]

I am completely confused at this point. Taking into consideration that the cattle panel greenhouse is not well sealed (to say the least) it seems to have gotten colder. The inside temperature at night is always 5 degrees below the outside. This morning it was 20 inside and 25 outside.

I'll be doing some more sealing today, but I need to figure this out or it won't even be useful for season extension.

Did you insulate the floor?

Jesus is Lord and Christ